2D-Datarecording Debus & Diebold Meßsysteme GmbH

>> Upgrade-Kits

	High sampling rate incl. swapable memory for 4 hours	GPS-Kit	Lambda – A/F-Kit	Sensor-Kit	2-stroke Deto-Kit
Description	Upgrade kit for the increase of the sampling rates and extension of the recording time. Swapable memory, also usable for endurance race or extended memory for small 2D logging systems.	GPS module with external, active antenna. Plug&Play technology with CAN-interface for simple connection with the datalogger	Wideband probe with electronic unit and CAN interface for simple connection with the datalogger.	Two high-quality linear potentiometers for suspension measurements (front and rear) and brake pressure sensor	Detonation Kit for the optimal tuning of engine/carburetor, inclusive exhaust gas temperature and detonation sensor. Plug&Play technology with CAN-interface for simple connection with the datalogger.
Technology	Increase of the sampling rate from datalogger RPM: 25 Hz => 100 Hz Front speed: 25 Hz=>50 Hz Rear speed: 25 Hz=>50 Hz TPS: 25 Hz=>100 Hz temperature: 12,5Hz=>25 Hz Brake pressure: 50 Hz=>100 Hz Front suspension: 50 Hz=>100 Hz Rear suspension: 50 Hz=>100 Hz	High accuracy: up to 2,5 m deviation from absolute cartesian coordinates Speed over Ground: precise speed measurement Trackmapping: The driven line is stored in real time.	High quality BOSCH-LSU wideband probe with fast evaluation electronic (400Hz) The Lambda kit can be used also as single device (e.g. at the test stand).	Linear potentiometers are water resistant (IP67)	High sampling rates up-to 400 Hz.
Technology				150mm front suspension 75mm rear suspension brake pressure (M10x1) / 100 bar	Exhaust gas temperature sensor (Type-K) up-to 1000°C Detonation sensor (14mm) to measure cylinder detonations and combustion chamber pressure).
CAN-Interface	Yes	Yes	Yes	No	Yes
Recording time	4 hours	-	-